Anchor Plate

ANCHOR PLATE ATTACHMENT - STEEL STUD FRAMING OR FURRING

RECOMMENDED TOOLS

  • Screw Gun
  • Locking C-Clamps
  • Pliers to cut shims
  • Drill with bits
  • 48” level & 24” level
  • Dead Blow Hammer
  • Circular Saw with dry and or wet diamond tipped blade
  • Screw Drivers (pry panels when shimming

INSTALLATION MATERIALS

  • Glazier’s Horseshoe shaped shims 1/16? , 1/8” & ¼”  thickness by 2 1/2?  long minimum
  • No. 8 Phillips Head Tek Screws
  • Spray mixture of 75% water and 25% mild dish soap
  • Dow Corning 795 Structural Silicone
  • Masking Tape

FRAMING CONSTRUCTION

Steel stud or furring should be true and plumb and must have a maximum deflection limited to L/240, and not to exceed allowable stresses. Lateral support and bridging should be installed. This does Not provide lateral support for wall framing.

The steel stud framing should have a maximum variation from a true plan of 1/8 inch in 10 feet. Defects must be corrected prior to proceeding with HyComb panel installation. Framing studs must be located with studs at panel joint locations.

JOBSITE STORAGE

Panels must be stored in a clean dry area, free from contaminates. The panels must be placed on a shock absorbent support such as expanded polystyrene to protect the edges, upon removal from the packaging crate.

HyCOMB panels are impact resistant and extremely durable, but, as with any Natural Stone facing, it is susceptible to chipping on theedges and the face surfaces ( especially with softer stones: Limestone, Travertine, etc…) Special care and protection should be taken in handling and staging of the product.

To be efficient all panels should be arranged in the order needed for installing.

INSTALLATION

The following instructions are intended for Vertical wall panels only.

  • Coordinate with the shop drawing to laser lever to mark the exact panel location and the position of panel edges at the base of the wall. Assure that each panel edge will have framing support.
  • Use a laser or level to establish the most outward point of the framing. Create a mark to determine the installation “plane” and the amount of shimming required. Use a string line from the top of the elevation to the bottom of the elevation. The string line should be set at least 2 inches from the most outward point of framing. This will be your reference line from where you will measure back from to establish the plane for all of the HyCOMB USA panel faces.
  • It is best to start with the bottom rows, and work to the top. If stacking the panels they must be fully supported on a padded flat surface faced down. The panel must be supported in the center, it is important to apply structural silicone to the center of the panels.
  • Set stone panel in place, lean it forward, and apply a walnut sized glob of structural silicone 24? on center to the framing members to the center of the stone panel.
  • The stone panel must be held in place and clamped withpadded C-clamps to the framing and shimmed as needed. It may be necessary to place shims between the back of the anchor plate and the farmings to property align the panel.
  • Installation may progress vertically or horizontally depending on how the panels have been staged. Please pay special attention when aligning panel joints as the panels are installed, shimming as necessary to maintain joint spacing. Once the panel has been properly positioned and shimmed, clamp the anchor plates on the leading edge of the panel to the framing and screw attach the anchor plates on the opposite edge through the joint to the framing.
  • At the end of each day remove anydirt or debris from the face of the stone to protect the surface.